Lithofin MN Builders Clean - 1 Litre
Additional Products (Optional)
- Downloads Lithofin MN Builders Clean Safety Data.pdf, Lithofin MN Bulders Clean Technical Data.pdf
Cleans granite, gneiss, quartzite and other natural and engineered stones. Removes cement films and other stubborn dirt residues, blooms, efflorescence and rust discolourations. Also helps to prevent rust in hard stone containing iron. NOT suitable for polished marble, polished limestone, polished travertine
Lithofin MN Builder’s Clean disolves and removes cement and mortar residues, efflorescences, limescale deposits, stubborn ingrained dirt, rust and rust discolourations.
The yellowish discoloration which results from iron containing stones rusting is removed and largely prevented.
Field of Use:
For removing cement residues from newly installed surfaces, for thoroughly cleaning used surfaces and for removing rust and rust discolourations. Lithofin MN Builder’s Clean prevents rust discolourations, which occasionally appear when cleaning iron containing stones such as serrizzo, cresciano, calanca, sardo white, etc. The product is therefore particularly suitable for those stones.
Surfaces: suitable for all acid resistant natural stones such as granite, gneiss, quarzite as well as rough manufactured (concrete) stones.
Please Note: not suitable for polished and finely honed limestones (marble) and manufactured stones. Always try the product in an inconspicuous area prior to use, since especially blue and black “granites” are often damaged.
Directions for Use:
First wet the surface, then apply Lithofin MN Builder’s Clean – diluted with water up to 1:10, depending on the type of dirt – and immediately spread the product evenly on the surface with a scrubbing brush. After a few minutes, scrub the surface then wash away with clean water. Do not allow the product to dry on the surface. In stubborn cases this procedure may have to be repeated.
Advice: in case of extremely stubborn, repeated rust discolourations we recommend Lithofin BERO.
Please Note: Lithofin MN Builder’s Clean is not suitable for polished or finely honed surfaces which are sensitive to acid such as limestone, marble, manufactured stone, etc.
In cases of doubt, try the product in an inconspicuous area.
Surfaces such as chrome, enamel, wood, and similar acid sensitive surface must be protected against splashes and vapours. Acid containing cleaners can develop vapours which may damage sensitive surfaces. We highly recommend carefully washing the product off the surface and ensuring good ventilation during and after use.
approx. 15 to 30m² depending on dirt up to 50m² on polished surfaces.