Pre-blended, ready to use mortar with normal setting and controlled shrinkage for fast-drying bedding of 20mm porcelain. Full Pallet - 40 x 25kg
FULL PALLET - 40 x 25kg - FREE ECONOMY DELIVERY (Approx. 2-3 WORKING DAYS)*
*Full pallet deals are shipped directly from Mapei. For same day despatch, orders need to be placed before 12.30pm. A tail-lift will be specified for the unloading of the pallet. Please include any important delivery instructions/access in the "Notes" when completing your order.
Next Day Delivery is available for £42 (including VAT).
Pre-blended, ready to use mortar with normal setting and controlled shrinkage for fast-drying bedding.
CLASSIFICATION
APPLICATION PROCEDURE
Preparation of the product
Mix a 25 kg bag of MapePave Mortar with 1.55-1.8 litres of water for at least 5 minutes in a cement mixer, automatic pressure pump or truck mixer until a homogeneous mix is obtained. Product can be mixed with a robust paddle mixer with care if required. The mix must be poured, compacted and floated within 40-60 minutes after mixing.
CONSTRUCTION METHOD WHEN INSTALLING PORCELAIN PAVERS
Bases must be constructed with stability and not prone to settlement.
Tiles installed on concrete bases can be installed in accordance with BS5385 part 3.
If the mortar is to be used on a concrete surface for levelling purposes the mortar should be installed 10mm – 100mm and bonded to the concrete surface with the Mapepave Slurry. Once the substrate has been prepared sufficiently, and immediately before spreading on the MapePave Mortar mix, prepare bonding slurry Mapepave Slurry according to the Technical Data Sheet and packaging. Apply a continuous, even 2-3 mm layer using a large flat brush, a scrubbing brush or a trowel. To ensure adhesion, spread the slurry onto the surface to be covered immediately before the MapePave Mortarmix (fresh screed on fresh slurry).
A type 1 MOT type installation compacted by mechanical means at a minimum depth of 100mm with restraint should provide a suitable base for the MapePave Mortar when used in no vehicle trafficked locations.
The mortar should be applied at a thickness no less that 25mm on a compacted type 1 MOT.
Spread the MapePave Mortar mix just like any other cement-based screed mix: use screed guides, then spread the mix and tamp thoroughly before floating to obtain a better surface finish.
To get perfect adhesion between the Porcelain Paver and the MapePave Mortar, spread the MapePave Slurry while the MapePave Mortar is still fresh (fresh on fresh technique).
Ensure surface is protected from rain or wash out until fully cured.
Grouting can be carried out after 12 hours.
Do not install in temperatures lower than +5°C.
MAPEPAVE MORTAR
Pre-blended, ready to use mortar with normal setting and controlled shrinkage for fast-drying bedding
SET TO LIGHT FOOT TRAFFIC
Floors are ready for foot traffic after approx. 12 hours.
READY FOR USE
The surfaces may be put into service after approx. 4 days.
CONSUMPTION
15 kg/m² per cm of thickness.
PACKAGING
MapePave Mortar is available in 25kg bags.
STORAGE
MapePave Mortar may be stored for up to 12 months in its original packaging in a dry place.
SAFETY INSTRUCTIONS FOR PREPARATION AND APPLICATION
Instructions for the safe use of our products can be found on the latest version of the Safety Data Sheet, available from our website www.mapei.co.uk.
PRODUCT FOR PROFESSIONAL USE.
