A low maintenance film forming surface sealer & protector.

• Enhances and embellishes the appearance.
• Highly resistant to wear and stains. Facilitates maintenance and cleaning.
• Leaves surfaces with a ‘just washed’ look.
• Suitable for exterior & interior use.

Directions for use
Preparation:
Newly installed surfaces - ensure surface to be treated is completely clean, dry and free from cement and grout stain (see LTP Cement, Grout & Salt Remover).
Existing surfaces - first clean and degrease surfaces with LTP Grimex Intensive Cleaner and rinse well.
Leave to dry out thoroughly (24 hrs).

Application:
Clean and dry surface - apply using a foam roller, sealant applicator pad or paint brush. Pour content into a separate container or dip tray. Apply to the surface without rubbing until an evenly thin film is created. Allow to dry (1 hr). For a more enhanced appearance further coats should be applied at right angles to the first (max.4).
Do not over apply as a heavy layer or too many coats may cause unsightly build up/affect slip resistance and/or reduce the efficiency of the product.
Hardens after about an hour but will take a further three days to achieve full hardness and become fully resistant.
Always test first to establish the correct method of application and optimum number of coats before general use.
Avoid extremes of temperature. Surface temperature range for application between 5ºC - 25ºC

Coverage
Approximately 30-40m2 per litre (one coat) depending on substrate texture.

Aftercare
Routinely sweep surfaces. Mop regularly using LTP Porcelain Floor Tile Cleaner. At some stage, (every 2 – 3 years) complete renovation may be desired.
In this case use LTP Solvex to strip the original coating before re-applying. Regular cleaning with steam
cleaners, jet washers and strong detergents should be
avoided.
Storage information: Store in a cool, dry, frost-free environment.
Shelf life: Up to 2 years for un-opened containers.