EcoProTec - Joint Residue Remover for Paving, Porcelain and Stone - 1 Litre - REDUCED TO CLEAR

EcoProTec - Joint Residue Remover for Paving, Porcelain and Stone - 1 Litre - REDUCED TO CLEAR

£11.86 inc.VAT (£9.88 ex.VAT)
In Stock (7)

A low odour non caustic treatment that softens residues left by jointing compounds and grouts making removal from the surface of natural stone, glazed ceramics and porcelain much easier.

Additional Products (Optional)

£11.86 inc.VAT (£9.88 ex.VAT)
Adding to cart… The item has been added

Have a question? Get in touch

01937 534577

Share this

  • Downloads

Softens hard to remove epoxy, acrylic and silicone residues left by cement free brush in jointing compounds making removal easier. A low odour non caustic treatment that softens hard to remove epoxy, acrylic and silicone residues left by cement free brush in jointing compounds making removal from the surface of natural stone and porcelain paving much easier. For use with paving, porcelain and stone.

Directions for Use:

SHAKE WELL BEFORE USE.
Always test on an inconspicuous area prior to general use.

Preparation:

Ensure that the surface to be treated is completely clean and dry. If necessary, first wash surfaces with
ECOPROTEC Intensive Cleaner. Rinse well with water to finish and leave to dry

Removing Residues:

Apply generously by dabbing or rolling onto the surface. Work in manageable areas at a time and do not brush out. Leave for up to 30 minutes.
If drying should occur within 30 minutes apply a little more solution to keep it wet. Use a stiff short haired brush or nylon scrubbing pad to remove the softened residues from the surface. Add a little water and scrub again. Extract the released residues using a sponge or wet vac and rinse with water. Repeat the process if unwanted material remains.

To Finish:

Use ECOPROTEC Intensive cleaner dilute 1: 5 in warm water. Apply with a light pressure sprayer or watering can. Agitate the surface using a deck brush or nylon scrubbing pad. Rinse by hosing off thoroughly with clean water.
Do not use when surface temperatures are under 5°C or over 25°C.

Coverage: M2 per application
Surface cleaning:

  • 1 LTR - 10m²
  • 5 LTR - 50m²

In extreme cases:

  • 1 LTR - 3m² 
  • 5 LTR - 15m²

Other

Do not apply during rain, frost, or when surface and air temp is under 5°C or over 30°C.Use gloves and protective goggles if there is a risk of direct contact or splashing.
Empty containers are recyclable.
Clean application tools and brushes with water after use.
Once cleaned: Protect porous stone and porcelain with ECOPROTEC Ultimate Sealer or Patio Sealer or Colour Enhancing Sealer.

Related Products